查看文章

In the general rule of casting design the thickest part of the cast should be placed near to the ingate. This arrangement was meant to guarantee the completion of filling process. An unusual vertical casting design to produce plates with different thicknesses was established based on the idea that the heat from molten metal will always warm up its entire runner. In this design the thinnest plate is placed near to the ingate. The design was made for producing thin wall ductile iron. This research was conducted to see the effects of reverse thickness arrangement in casting design to the microstructure and mechanical properties of the plates. Plates produced by this design were compared to plates produced by the same design with general casting arrangement. Thicknesses of the plates produced in this casting were 1, 2, 3, 4, and 5 mm. The moulds used were made from furan sand. Beside experiment, casting design …