… sprayed, cost, effect of substrate geometry etc, the APS process grabs the attention of the
industries. Additionally, the plasma spray coating … melting of the material during plasma spray …

… surfaces: the angle of the laser tracks, and the ratio of the melted surface on the tribological
behaviour of NiCrBSi plasma spray coatings partially melted by laser. The research showed …

… ) with 2θ diffraction angle ranging from 20 … melted or partially melted at high temperature
and impact on the substrate surface. Due to the short spray distance, the front end of the plasma …

… unmolten or partially molten particles [21]. The integrity of any plasma sprayed coating is to
… The diffraction angles (2θ angle) was set in the range from 20 to 100. The microhardness of …

… study the geometric morphology of materials. The tribological properties of the coating were
… particles on the substrate, the liquid metal partially melted spreads around to form a flat layer…

… -Brentano focusing geometry in a 5 o –80 o range using the CuK λ (λ = 0.154059 nm) radiation.
… The coating had some microcracks and partly melted powder fragments on the surface. …

… The main reasons are as follows: (I) the NiCrAlY powder with relative low melting point can
be enough melted in plasma spraying process, which is beneficial to increase compactness …

… of the plasma sprayed Al 2 O 3 coatings. … effects of re-melting the as-sprayed coatings with
various parameter laser beam on the tribological and mechanical properties of the coatings…

… tribological and mechanical properties of the substrate. In the present work, HA powder was
plasma sprayed … This is attributed to the rebound action of unmelted or partially melted HA …

… Plasma spray coating carried out using a plasma spray … The XRD pattern shows high peaks
at 44.3 diffraction angle (2θ) … and the molten alloy powder through thermal spraying. Hence …