… with the corresponding high density ratio, we adopt a virtual-density scheme similar to that
… -liquid layer might be mistakenly attributed to the liquid/gas phase. This can be avoided by …

… spurious currents, inability to handle the large density ratio and thermodynamic … LBM in
boiling where pool boiling heat transfer, flow boiling heat transfer and boiling on porous surface …

… boiling regime is dominated by the nucleation site density and … found that the bubble growth
rate in NaCl solutions was the … , and migration of the liquid-gas interface can be mimicked …

… , in the LB boiling simulations, the fluid density near the heating … treats the evaporation/condensation
rate at the liquid–vapor … boiling stages of pool boiling, ie, nucleate boiling, transition …

… the density ratio was significantly improved to 200 in their study, which was very difficult for
the boiling research based on the pseudopotential LB model. … The density distribution function …

… pool boiling heat transfer from a plane and with protruding surface using single component
pseudo-potential phase change model of lattice Boltzmann … for large density ratio as high as …

… at very low saturated temperature for a liquid–vapor density ratio around 200. Sadeghi et al…
lattice Boltzmann model for the simulations of pool boiling with high liquid–vapor density ratio…

… In such energy systems, efficient boiling helps in removing high power density across the …
The bubbles form at an increasing rate at a larger number of active nucleation sites as we …

… Since the convection cycle is caused by gravity and density difference, … , lattice Boltzmann
simulations of pool boiling under heaving conditions are performed. First, the simulated boiling …

… pseudo-potential LB model. Nevertheless, only when the liquid–gas density ratio is less than
… The specific structure of the pool boiling computational domain with the dimension of 8.83 l …