The measurement of tissue attenuation from pulse-echo data has been widely investigated.
This paper examines correction of the measurements for the effect of the transducer beam. …

… addressed through experimental measurements of focused, pure-tone beam patterns under
… First, measurements in water provide a comparison of the beam patterns of the fundamental …

… In estimating the freguency-dependent attenuation coefficient, we analyzed the range-dependent
ultrasonic beam and proposed … And this method can be applied In vivo measurement. …

… This knowledge will aid in the experimental design of highly accurate attenuation
measurements. Accurate single integral equations for the attenuated full beam pattern are derived …

… errors when measuring the X-ray linear attenuation coefficient, μ… beam irradiation geometry
is considered, and scatter acceptance angles, equal to the sum of the incident and exit beam …

… Attenuation measurements performed along the beam axis of a circular aperture piston
source are interpreted by assuming the existence of this factor. It is important to determine under …

… An intensity calibration is developed based on radiation force measurement of total
power and main lobe beam patterns, using embedded thermocouples and short bursts …

… beams were used to correct the laser sheet attenuation. The camera position relative to the
laser sheet beam … symmetric spray pattern may be measured as an asymmetric pattern due to …

… of that material before allowance is made for the nature of the radiation pattern of the sound
beam, the effect of the geometry of the sample, and the effect of the boundary conditions of …

… If a small hydrophone is used for attenuation measurements, multiple points should be used
to reconstruct beam patterns over a plane. This enables a summation to be made of the total …