Purpose: This study compared the microshear bond strengths to ground enamel of three one-
step self-etching adhesive systems, a self-etching primer system and an etch-and-rinse …

Purpose: To measure the microtensile bond strength to enamel and dentin of three self-
etching adhesives in comparison with a total-etch two-step system as a control. Materials …

Purpose: This study tested the effect of different drying times on the efficacy of bond for five
self-etching adhesives. Materials and Methods: Four marketed and one experimental …

The purpose of this study was to evaluate the effect of surface roughness and smear layer
on the micro-shear bond strength (µSBS) of two self-etching adhesives, Clearfil SE Bond …

Purpose: To assess the one-step self-etching adhesive iBond Gluma inside (1-SE) and the
two-step etch-andrinse adhesive Gluma Comfort Bond (2-ER), both used in combination …

Purpose: To evaluate the influence of thermal and mechanical load cycling on the
microtensile dentin bond strength of two self-etching and one total-etch adhesives. Methods …

OBJECTIVES: To evaluate dentin wettability and bonding of self-etching and total-etch
adhesives on smear layer-covered and smear layer-free dentin. METHODS: Three self …

This study measured the immediate and 24 h shear (SBS) and micro-shear bond strengths
(MSBS) to dentin of four self-etching adhesives. A resin composite was bonded using each …

Objective. To test the hypothesis that some single-bottle self-etching adhesives bond as well
to enamel and dentin as a typical two-bottle etch-and-rinse adhesive. Material and methods …

Purpose: This study tested the null hypothesis that the preparation of the enamel surface
would not affect the enamel microtensile bond strengths of self‐etching adhesive materials …