Purpose: To evaluate the role of adhesive composition (solvent and filler content) on
rnicrotensile bond strength (µTBS) to human dentin. Materials and Methods: 15 third molars …

Purpose: The purpose of this study was to examine the sensitivity of the microtensile bond
strength (µTBS) to changes in the specimen design using three different dentin bonding …

Materials and methods Twenty-five flat enamel and dentin bonding sites were prepared to
600 grit on human molar teeth. The Clearfil Liner Bond 2 adhesive system was used to bond …

Objectives: The objective of this study was to test the hypothesis that bond strengths to intact
class II cavity wall surfaces are lower than those measured on corresponding flat surfaces …

Objective. The aim of this study was to test the hypothesis that the effects of filling technique,
cavity configuration and use of a low-viscosity composite liner influence resin bond strength …

OBJECTIVES: One-bottle dentin adhesives combine primer and adhesive resin into a single
solution. This study was conducted to determine the bond strengths to dentin of four one …

Objectives. The purpose of this study was to test the null hypothesis that there is no
relationship between the bonded surface area of dentin and the tensile strength of adhesive …

Purpose: To evaluate the microtensile bond strength (µTBS) of eleven contemporary
adhesives to dentin, including three one-step self-etch systems, four two-step self-etch …

Purpose: This study evaluated the microtensile bond strengths of three dentin adhesives
applied on clinically moist dentin or on dentin that was dried with air for 5 seconds. The null …

OBJECTIVE: The purpose of this study was to investigate if incremental-filling technique and
cavity size would affect the bond strength of resin composite. METHODS: Two sizes of Class …