… cure cycles which reduce the cure-induced stresses in single fiber/matrix model composites.
In this … A comparison of Figures 7 and 8 shows a good correlation between polymer volume …

… A method based on total stress-strain-temperature relations is … the curing stresses in
boron/epoxy composite lam inates. This method is shown to be preferable to the incremental method …

… Results for both fibers show a large reduction in stresses … that stresses develop inside
a thermoset polymer composite … is good correlation between the polymer volume change (Fig. …

… The correlation between the observed values of curvature and … Chapter 3 describes the main
techniques used for the … cure, residual stresses previously frozen into the part are released …

… This new method was developed to monitor fiber stresses … A good correlation between fiber
tension and volume change … The effect of initial temperature will be discussed in Chapter 3. It …

… composite material. The effects of dwell temperature, dwell time, cool-down rate, cool-down
pres sure, and postcure on residual stresses … that residual stresses can be reduced by as …

… For reinforced composite materials, thermoset polymers are … Above a temperature of 160℃,
a good correlation was not found … , process-induced residual stresses of composite materials …

… of the composites surface which imparted additional stresses. … This correlation is typically
done by applying a model which … the DHD technique to measure cure induced residual stress. …

… Complex gradients in temperature and degree of cure are predicted and the influence of
the tool on the curing process is demonstrated. Correlation between experimentally measured …

… strategy to compensate the cure-induced distortions of the curved C-Spar. … And this strategy
described in Section 3. … This new method achieves the purpose of producing curved plate …