… In this manuscript, in contrast to earlier reports, sulfate species are identified that are … species
after aqueous work up. Our results are based on bulk characterization of graphene oxide by …

… C═C/C−C (284.7 eV) species, and a minor component of the O═C−O (carboxyl, 288.8 eV)
species. After the chemical reduction, the oxygen species of C−O (hydroxyl and epoxy, 286.5 …

Nitrogen (N) and sulfur (S) codoped reduced graphene oxide (N,S-rGO) was synthesized
through a facile solvothermal process. The introduction of N and S heteroatoms into GO …

… Recently, chemisorption effect between sulfur species and some specific hosts have been
proved to efficiently trap and immobilize sulfur species. Several metal oxides, such as Mg 0.6 …

… 2 SO 3 and Li 2 SO 4 species, respectively. It should be mentioned that these two peaks
may be also from the sulphate species formed by oxidation of sulfur. After 1 cycle, the damping …

… In this study, the geometries of all the species were fully optimized without any symmetry …
, products or minima associated with intermediate species). The thermal corrections to the …

… graphene oxide. This approach enabled us to obtain a uniform and thin (around tens of
nanometers) sulfur coating on graphene oxide … to the reduction of polysulfide species to form Li 2 …

… is composed of a thin and uniform sulfur film anchored on a graphene oxide (GO) sheet. The
… sulphate species formed by oxidation of sulfur in air. Note here that all the species revealed …

… graphene oxide by excitation with nonthermal plasma or/and thermal treatment, as an oxidized
or nonoxidized sulfur … The oxidation state of the adsorbed sulfur species depended on the …

… titanium oxide (TiO 2 )/reduced graphene oxide (rGO) composite structure (TG) as a sulfur
… , while the polar TiO 2 in TG/S shows strong chemical interaction towards the sulfur species. …