Estimation of temporal parameters during sprint running using a trunk-mounted inertial measurement unit

E Bergamini, P Picerno, H Pillet, F Natta… - Journal of …, 2012 - Elsevier
The purpose of this study was to identify consistent features in the signals supplied by a
single inertial measurement unit (IMU), or thereof derived, for the identification of foot-strike …

Validation of an inertial measurement unit for the quantification of rearfoot kinematics during running

D Koska, J Gaudel, T Hein, C Maiwald - Gait & Posture, 2018 - Elsevier
Background The popular protocol used to study running motion suffers from problems that
lead to a limited ability to generalize the obtained results. Inertial measurement units (IMU) …

Trunk inclination estimate during the sprint start using an inertial measurement unit: A validation study

E Bergamini, P Guillon… - Journal of applied …, 2013 - journals.humankinetics.com
The proper execution of the sprint start is crucial in determining the performance during a
sprint race. In this respect, when moving from the crouch to the upright position, trunk …

Stride and step length obtained with inertial measurement units during maximal sprint acceleration

CJ de Ruiter, JH van Dieën - Sports, 2019 - mdpi.com
During sprint acceleration, step length, step rate, ground contact, and airtime are key
variables for coaches to guide the training process and technical development of their …

Estimating running spatial and temporal parameters using an inertial sensor

DK Chew, KJH Ngoh, D Gouwanda, AA Gopalai - Sports Engineering, 2018 - Springer
An inertial measurement unit (IMU) is widely considered to be an economical alternative to
capture human motion in daily activities. Use of an IMU for clinical study, rehabilitation, and …

IMU-based determination of stance duration during sprinting

M Schmidt, C Rheinländer, KF Nolte, S Wille… - Procedia …, 2016 - Elsevier
Stride parameters like step length, step rate or stance duration during sprinting represent
basic and very useful information for track and field coaches. Contact mats or opto-electronic …

Detection of ground contact times with inertial sensors in elite 100-m sprints under competitive field conditions

P Blauberger, A Horsch, M Lames - Sensors, 2021 - mdpi.com
This study describes a method for extracting the stride parameter ground contact time (GCT)
from inertial sensor signals in sprinting. Five elite athletes were equipped with inertial …

The use of a single inertial sensor to identify stride, step, and stance durations of running gait

JB Lee, RB Mellifont, BJ Burkett - Journal of Science and Medicine in Sport, 2010 - Elsevier
Current developments in inertial sensor technology could enable the measurement of
running gait outside of the traditional laboratory environment. The purpose of this research …

Step-to-step kinematic validation between an Inertial Measurement Unit (IMU) 3D system, a combined Laser+ IMU system and force plates during a 50 M sprint in a …

R van den Tillaar, R Nagahara, S Gleadhill… - Sensors, 2021 - mdpi.com
The purpose was to compare step-by-step kinematics measured using force plates
(criterion), an IMU only and a combined laser IMU system in well-trained sprinters. Fourteen …

The use of a single inertial sensor to estimate 3-dimensional ground reaction force during accelerative running tasks

RD Gurchiek, RS McGinnis, AR Needle… - Journal of …, 2017 - Elsevier
The purpose of this investigation was to determine the feasibility of using a single inertial
measurement unit (IMU) placed on the sacrum to estimate 3-dimensional ground reaction …