Ceramic materials typically have to be sintered at high temperatures, often above 1000 C.
This precludes the coating of lower-melting substrate materials, such as metals, glasses and …

Cold spray is a fast growing coating process involving in high strain rate deformation of
spray particles. Early investigations stressed the retaining of feedstock microstructures into …

There is great demand for micro-or miniaturized actuators for practical application. However,
magnetic coils of electromagnetic motors are an obstacle to such miniaturization because of …

Lead zirconate titanate (PZT) films with a thickness of more than 10 µm were prepared by
the aerosol deposition method and their microstructure and chemical composition were …

Solid oxide fuel cells (SOFCs) are amongst the most widely used renewable alternative
energy systems with near-zero carbon emission, high efficiency, and environment-friendly …

Ceramic micro-stereolithography (μSL) was recently introduced in the fabrication of complex
3D ceramic microstructures. Light scattering is found as an important factor in the μSL of …

This article describes the challenges in focusing nanoparticles (< 30 nm) into tightly
collimated beams, and provide guidelines for designing aerodynamic lens systems for …

Powder aerosol deposition (PAD) is a unique ceramic spray coating method that produces
dense and well‐adhering thick‐films directly at room temperature, without requiring any …

The aerosol deposition method (AD) has recently attracted attention as a new room
temperature coating technique for titanium dioxide (TiO 2) and other ceramic particles …

Abstract Transparent Pb (Zr, Ti) O 3 (PZT) thin films with over 1 µm thickness were deposited
by the aerosol deposition method (ADM). The transparency of the PZT thin film deposited at …