In this study, we successfully address a significant research and engineering gap by
quantitatively assessing the impact of varying compressive loading rates on the mechanical …

Fused Granular Fabrication (FGF) or screw-extrusion based 3D printing for polymers is a
less diffused alternative to filament-based Additive Manufacturing (AM). Its greatest …

This work describes a method for 3D printing self-heating structures by embedding
conductive layers inside a thermoplastic matrix using a dual-nozzle setup. The method uses …

Suffering from creep and defects, thin-walled tubes and heat-resistant components
produced by additive manufacturing (AM) technology and laser repair were prone to failure …

In recent years, 3D printing has undergone a transformational journey–from prototyping
technology, limited to laboratories, to a production method used in industry–becoming a …

The use of polymer materials in various fields has increased significantly due to their ease of
thermoforming and relatively low production costs. The production volume of these materials …

Abstract 3D printing technology combined with thermoplastic polyurethane (TPU) is
increasingly being used in flexible electronics. However, the defects induced by 3D printing …

The article deals with the optimization of 3D printing conditions of the improved E3D
ToolChanger printer, which works on the basis of the Fused Deposition Modeling technique …

Implementationof material extrusion in the industry must overcome several issues regarding
the quality inherent in the printing process. The increasing use of additive manufacturing has …

In this study, the changes in tensile strength of PLA and ABS specimens, the most commonly
used materials in additive manufacturing with FFF, were investigated as a function of fill rate …