Today, a major issue about water pollution is the residual dyes from different sources (eg,
textile industries, paper and pulp industries, dye and dye intermediates industries …

Laser-powder bed fusion was identified as a promising technique for manufacturing metal
matrix composites. However, over a decade later, little progress has been made in …

The influence of heat treatment on the crystal structure, grain growth kinetics, orientation,
and refractive index properties of the ZnO film deposited onto p-type single-crystalline Si …

Berkovich nanoindentation-induced mechanical deformation mechanisms of AlN thin films
have been investigated by using atomic force microscopy (AFM) and cross-sectional …

In this study, the effects of post-annealing on the structure, surface morphology and
nanomechanical properties of ZnO thin films doped with a nominal concentration of 3at …

A polydopamine coating (coded as PDAc) was prepared successfully on a Si substrate
through a two-step process. Briefly, to improve the adhesion of PDAc on the Si substrate, a …

ZnO thin films grown on Si (1 1 1) substrates by using atomic layer deposition (ALD) were
annealed at the temperatures ranging from 300 to 500° C. The X-ray diffraction (XRD) …

In this investigation, CoFeB thin films were sputtered onto glass substrates with thicknesses
(tf) from 100 to 500Å under the following conditions;(a) substrate temperature (Ts) …

Dynamic scaling behavior has been observed during the room-temperature growth of
sputtered Au films on SiO 2 using the atomic force microscopy technique. By the analyses of …

In this study, the structural and nanomechanical characteristics of ZnO thin films are
investigated by mans of X-ray diffraction (XRD), atomic force microscopy (AFM) and …