High solid content (HSC) latexes are of growing interest for many reason, but making this
type of product entails many difficulties. Increasing the solid content (fraction of polymer …

Abstract β-tricalcium phosphate (β-TCP, β-Ca 3 (PO 4) 2) is one of the most attractive
biomaterials for bone regeneration and β-TCP macroporous scaffolds are very promising for …

Alumina mold materials prepared by stereolithography usually have considerable sintering
shrinkage, and their properties related to casting have been rarely studied. In this study …

Abstract 3D printing metals via material extrusion utilizes a metal particle reinforced polymer
matrix composite (PMC) as the filament which is typically made with gas-atomized powders …

One of the major challenges in emulsion polymerization over the past two decades was how
to increase the solid content of latex products. In contrast to the conventional latex, high solid …

This paper describes the influence of particle size distribution (PSD) of refractory silica on
the suspension viscosity, packing density, and segregation in layers solidified by ceramic …

Porous Si 3 N 4 ceramics with high strength and high transmittance have been widely used
in the field of defense and military. Additive manufacturing (AM) technology is one of the …

Materials that are either manufactured or occur in nature and used both in industry and in
our daily lives (metals, rocks, wood, soil, suspensions, and biological tissue) are very …

Additive Manufacturing (AM) technologies, with its utilization of 3D models for layer-by-layer
part fabrication, have the potential to revolutionize, and perhaps disrupt, conventional …

An experimental and modeling study was carried out to understand the relationship between
the viscosity of a multimodal latex and its particle‐size distribution (PSD) and polymer …