In this work, the microstructures of the electron-beam welded joints of cast Al–Cu–Mg–Ag
alloy plate were investigated in terms of the element segregation, grain structure and …

In this study, the creep response and microstructure evolution for the nugget zone (NZ) of a
friction stir welded Al–Cu–Li alloy under different stress levels are systematically …

The effect of Pt content dispersed in Ag-CuO fillers on the interfacial microstructure and
properties of Al 2 O 3 ceramic joints brazed in air was investigated. Pt addition did not …

The present study investigates the through-thickness microstructural evolution, particle
dispersion, and mechanical properties of the Al-Fe alloy system fabricated via friction stir …

In this study, rapid screening of creep resistance for additively manufactured (AM) materials
is enabled using an accelerated creep test (ACT) called the dynamic negative stepped test …

In this paper, the effects of an aging treatment on the corrosion resistance/mechanism of a
tensile deformed Al-Cu-Mn-Fe-Zr alloy are investigated. The impedance magnitude and …

Creep ageing forming (CAF) has been widely used in the aerospace engineering, but how
to optimize the processing conditions, especially under complex stress state of the CAF …

The influence of ultrasonic treatment (UT) on the microstructure morphology and hardness of
Al–Cu–Mg–Ag alloy is systematically investigated by a combination of electron backscatter …

The development of metal matrix composites is important for industrial applications that
require lightweight materials with high strength, stiffness, and wear resistance. In this …

The aim of this research was to investigate the effect of different heat treatment conditions of
AA2519 friction stir welded joints on their microstructure and residual stresses. The following …