This study deals with the analysis and usefulness of the material ratio curve. The parameters
obtained from this curve are presented. The most popular of these parameters include two …

INTRODUCTION: Tooth surface loss (TSL) is an increasingly recognised problem. We are
therefore seeing an increase in the number and complexity of in vitro studies investigating …

In this paper, the methods of compensation of differences in the results of entire bending-
fatigued fracture surface topographies were presented. The roughness evaluation was …

Accurate wear measurement is an important task. In this paper, measurements of wear
levels within the limits of the original surface topography using profilometric methods were …

This paper presents the results of the tribological experiments conducted using an
oscillating wear tester under lubricated conditions. Specimen from piston ring slid against …

The plateau surface evaluation methods proposed in ISO 13565 cannot be used to
consistently evaluate the running-in wear process. An evaluation method to calculate the …

The objective of the investigation was to identify surface roughness after turning with
wedges of coated sintered carbide. The investigation included predicting the average …

The experiments were carried out using an Optimol SRV5 oscillating wear tester under
lubrication. Specimens were cut from gray cast iron cylinder liners honed and/or plateau …

Duplex stainless steel (DSS) UNS S32205 presents high resistance to oxidation, corrosion,
and corrosion under stress associated with good mechanical properties, thus being widely …

Existing segmented separation method for differentiating the components contained within a
bi-Gaussian stratified surface has two drawbacks: 1) assumption of probability material ratio …