Hot working, as an important group of post-processing routes for additive manufacturing
technology (3D printing), is used to reduce the solidification/processing defects and …

Friction stir welding (FSW) is in existence for well over three decades. Started primarily with
the joining of aluminium alloys, FSW is gradually engaged for other alloys and also …

High-temperature flow features of the Al− Zn− Mg− Cu− Zr aluminum alloy was revealed by
hot compression tests. The evolution mechanisms of dislocation clusters, subgrain, and …

The hot tensile deformation behaviors of an Al–Zn–Mg–Cu alloy are studied by uniaxial
tensile tests under the deformation temperature of 340–460° C and strain rate of 0.01–0.001 …

In order to understand the constitutive behavior of as-cast AZ80 with large grain size, the
uniaxial hot compression tests were carried out over a series of isothermal upsetting …

Constitutive models were built based on the results of isothermal hot compression tests for a
6061 aluminium alloy at temperatures of 400, 450, 500, and 550° C and strain rates of 0.1, 1 …

The high-temperature tensile features of a 7046-aluminum alloy are researched by adopting
the hot tensile experiments under different forming parameters. The influences of tensile …

The hot deformation behaviors of three aluminum alloys containing different silicon contents
(S1: Al–0.6 wt.% Si–0.5 wt.% Mg; S2: Al–7.0 wt.% Si–0.5 wt.% Mg; S3: Al–12.3 wt.% Si–0.5 …

The hot deformation behavior of dual-phase Mg–9Li–3Al alloys was investigated by the
isothermal hot compression tests using the Gleeble-3500 thermal-mechanical simulation …

The thermal compression deformation behavior of homogenized Mg–5Zn–1Mn (wt.%) alloy
was systematically investigated over the temperature and strain rate ranges of 285–345° C …