Superparamagnetic nanosystems based on iron oxide nanoparticles for biomedical imaging
Magnetic iron oxide nanoparticles and their dispersion in various mediums are of wide
interest for their biomedical applications and physicochemical properties. MFe2O4 or …
interest for their biomedical applications and physicochemical properties. MFe2O4 or …
Characterization of H2S gas sensor based on CuFe2O4 nanoparticles
Abstract Copper ferrite (CuFe 2 O 4) nanoparticles were prepared by the sol-gel auto-
combustion method and used to construct a conductometric gas sensor in this work. The as …
combustion method and used to construct a conductometric gas sensor in this work. The as …
Photocatalytic activity evaluation of tetragonal CuFe2O4 nanoparticles for the H2 evolution under visible light irradiation
H Yang, J Yan, Z Lu, X Cheng, Y Tang - Journal of Alloys and Compounds, 2009 - Elsevier
Copper ferrite (CuFe2O4) nanoparticles have been successfully synthesized via a citric acid-
assisted sol–gel method. For comparison, CuFe2O4 materials were also fabricated by solid …
assisted sol–gel method. For comparison, CuFe2O4 materials were also fabricated by solid …
Simple synthesis of CuFe2O4 nanoparticles as gas-sensing materials
Z Sun, L Liu, D zeng Jia, W Pan - Sensors and Actuators B: Chemical, 2007 - Elsevier
Semiconductive nanometer-size material CuFe2O4 was synthesized by a low-heating solid-
state reaction of inorganic reagents of Cu (CH3COO) 2· H2O, Fe (NO3) 3· 9H2O and NaOH …
state reaction of inorganic reagents of Cu (CH3COO) 2· H2O, Fe (NO3) 3· 9H2O and NaOH …
Synthesis of metal ferrite (MFe2O4, M = Co, Cu, Mg, Ni, Zn) nanoparticles as humidity sensor materials
V Jeseentharani, M George, B Jeyaraj… - Journal of …, 2013 - Taylor & Francis
Humidity sensitivity of metal ferrite nanoparticles [MFe2O4, M (II)= Co, Cu, Mg, Ni and Zn]
prepared by solid-state reaction of inorganic precursors was studied. The process was …
prepared by solid-state reaction of inorganic precursors was studied. The process was …
Improved performance of CuFe2O4/rGO nanohybrid as an anode material for lithium-ion batteries prepared via facile one-step method
Background: CuFe2O4 nanoparticles possess good electrochemical properties apart from
their inadequate electronic conductivity and large volume variation. The resulting …
their inadequate electronic conductivity and large volume variation. The resulting …
[HTML][HTML] Up-scalable synthesis of size-controlled copper ferrite nanocrystals by thermal treatment method
LB Zakiyah, E Saion, NM Al-Hada… - Materials Science in …, 2015 - Elsevier
Close-packed cubic copper ferrites (CuFe 2 O 4) nanoparticles were synthesized using an
effective thermal-treatment method directly from an aqueous solution containing copper and …
effective thermal-treatment method directly from an aqueous solution containing copper and …
Preparation and gas-sensing properties of CuFe2O4 at reduced temperature
S Tao, F Gao, X Liu, OT Sørensen - Materials Science and Engineering: B, 2000 - Elsevier
Sol-gel and co-precipitation were used for preparation of copper ferrite. Pure CuFe2O4 was
not obtained until 800° C by a sol-gel process, which might be due to the loose contact …
not obtained until 800° C by a sol-gel process, which might be due to the loose contact …
Magnetic and catalytic properties of inverse spinel CuFe2O4 nanoparticles
In this research, inverse spinel copper ferrite nanoparticles (CuFe 2 O 4 NPs) were
synthesized via citrate-nitrate combustion method. The crystal structure, particle size …
synthesized via citrate-nitrate combustion method. The crystal structure, particle size …
Selective hydrogen gas sensor using CuFe2O4 nanoparticle based thin film
Hydrogen gas sensors based on CuFe 2 O 4 nanoparticle thin films are presented in this
work. Each gas sensor was prepared by depositing CuFe 2 O 4 thin film on a glass substrate …
work. Each gas sensor was prepared by depositing CuFe 2 O 4 thin film on a glass substrate …