A review on lubricant condition monitoring information analysis for maintenance decision support
JM Wakiru, L Pintelon, PN Muchiri… - Mechanical systems and …, 2019 - Elsevier
Lubrication Condition monitoring (LCM) is not only utilized as an early warning system in
machinery but also, for fault diagnosis and prognosis under condition-based maintenance …
machinery but also, for fault diagnosis and prognosis under condition-based maintenance …
A review of gerotor technology in hydraulic machines
PJ Gamez-Montero, E Codina, R Castilla - Energies, 2019 - mdpi.com
Over the years, numerous investigations have established the gerotor fundamentals. This
work aims to provide a complete review of the literature from the last decade, focusing on the …
work aims to provide a complete review of the literature from the last decade, focusing on the …
A performance prediction method for pumps as turbines (PAT) using a computational fluid dynamics (CFD) modeling approach
Small and micro hydropower systems represent an attractive solution for generating
electricity at low cost and with low environmental impact. The pump-as-turbine (PAT) …
electricity at low cost and with low environmental impact. The pump-as-turbine (PAT) …
Flow characteristics of gerotor pumps with novel variable clearance designs
CF Hsieh - Journal of Fluids Engineering, 2015 - asmedigitalcollection.asme.org
Although gerotor pumps are used in a wide range of industrial applications, higher work
pressure causes shock or collision among pump components, which leads to large stress …
pressure causes shock or collision among pump components, which leads to large stress …
A tridimensional CFD analysis of the oil pump of an high performance motorbike engine
The main target of nowadays engine designers is to focus on exhaust emissions, fuel
consumption and engine performance, so during the design phase of a new internal …
consumption and engine performance, so during the design phase of a new internal …
Numerical analysis and experimental validation of Gerotor pumps: A comparison between a lumped parameter and a computational fluid dynamics-based approach
In this paper, two alternative numerical approaches for the simulation of Gerotor units are
compared: a fast lumped parameter approach for the fluid dynamics through the unit that …
compared: a fast lumped parameter approach for the fluid dynamics through the unit that …
[HTML][HTML] Simulation approaches for the study of the oil flow rate distribution in lubricating systems with rotating shafts
This study addresses the issue of predicting the distribution of lubricant flow through the
outlets of a rotating shaft used in vehicle power transmission. A typical geometry with closely …
outlets of a rotating shaft used in vehicle power transmission. A typical geometry with closely …
Comparison of the performance of artificial neural networks and fuzzy logic for recognizing different partial discharge sources
This paper compared the capabilities of the artificial neural network (ANN) and the fuzzy
logic (FL) approaches for recognizing and discriminating partial discharge (PD) fault …
logic (FL) approaches for recognizing and discriminating partial discharge (PD) fault …
A modeling approach to study the fluid-dynamic forces acting on the spool of a flow control valve
This paper introduces an approach to study a valve's internal fluid dynamics. During
operation, the flow causes forces on the spool. These forces must be correctly balanced …
operation, the flow causes forces on the spool. These forces must be correctly balanced …
Modelling approach on a Gerotor pump working in cavitation conditions
Gerotor pumps are widely used on engine hydraulic circuits. The design of these pumps is
mainly focused on the study of the leakages through the rotors. Modelling or experimental …
mainly focused on the study of the leakages through the rotors. Modelling or experimental …