Biaxial weft-knitted fabrics as composite reinforcements: A review

H Hasani, S Hassanzadeh… - Journal of Industrial …, 2017 - journals.sagepub.com
Textile products are considered as an acceptable alternative for commonly used composite
reinforcement due to their lightweight as well as relatively high specific strength and …

Rotational performance of glulam bolted joints: Experimental investigation and analytical approach

Z Shu, Z Li, X Yu, J Zhang, M He - Construction and Building Materials, 2019 - Elsevier
Glulam bolted joints with slotted-in steel plates are commonly seen type of joints for post and
beam timber structures. This paper provides a systematic study on the rotational …

Comparison of glulam post-to-beam connections reinforced by two different dowel-type fasteners

M He, H Liu - Construction and Building Materials, 2015 - Elsevier
In this paper, the performance improvement of glulam post-to-beam connections reinforced
by plain round rods (PRRs) and self-tapping screws (STSs) were compared. Five non …

Experimental study and theoretical analysis on the flexural behavior of glulam bolted joints with prestressed steel strips

H Liu, J Zhao, S Zhao, S Yang, Z Chen - Engineering Structures, 2022 - Elsevier
The glulam bolted joint with prestressed steel strips was proposed and investigated
systematically. Experimental study was conducted considering the variation of pre-strain of …

Cyclic response of moment-resisting glulam hybrid joints with bolts and side steel plates

J Zhang, J Yi, Y Xu, M Zhang - Journal of Building Engineering, 2022 - Elsevier
To improve the cyclic properties of moment-resisting bolted glulam joints, H-shaped steel
flange plates with openings and side steel plates with reduced section are applied and …

Mechanical performance of glulam beam-column moment-resisting connections with self-tapping screws as fasteners

L Fang, L Wang, W Qu, S Zhang - Journal of Building Engineering, 2022 - Elsevier
The innovation and improvement of connection technology is an important topic in the field
of timber structure. With the development of manufacture process, the self-tapping screws or …

Short-and long-term performance of bonding steel-plate joints for timber structures

B Shi, H Yang, J Liu, R Crocetti, W Liu - Construction and Building Materials, 2020 - Elsevier
The long-term performance of bonding steel-plate joints in controlled environmental
conditions in this work. The bonding steel-plate joint consists of a steel plate with a …

Experimental investigation on lateral performance of pre-stressed tube bolted connection with high initial stiffness

M He, Y Zhao, R Ma - Advances in Structural Engineering, 2016 - journals.sagepub.com
This article presents an experimental study on the moment-resisting capacity and stiffness of
the proposed pre-stressed tube bolted connection. High-strength bolts with tubes were used …

Textile technologies for the manufacture of three-dimensional textile preforms

N Ishmael, A Fernando, S Andrew… - Research Journal of …, 2017 - emerald.com
Textile technologies for the manufacture of three-dimensional textile preforms | Emerald Insight
Books and journals Case studies Expert Briefings Open Access Publish with us Advanced …

Strengthening single-bolt timber joints with externally bonded CFRP composites

JQ Yang, ST Smith, YF Wu, P Feng - Structures, 2020 - Elsevier
Dowel type timber joints are popular in timber construction and they can be used in timber
trusses and moment resisting frames (ie beam-to-column joints). Bearing strength is an …