Abstract The dual-phase AlCoCrFeNi 2.1 eutectic high-entropy alloy (EHEA) presents a
promising solution to the strength-ductility trade-off dilemma, making it a highly desirable …

Abstract One binary Zn–15Al, five ternary Zn–15Al–Cu and six quaternary Zn–15Al–3Cu–Si
alloys were prepared by permanent mold casting. Their microstructures and mechanical …

High-Zn aluminum casting alloys usually contain coarse dendrites, network eutectoid
structure and casting defects which deteriorate the mechanical properties seriously. In order …

Solution treatment and natural aging have been carried out to enhance the mechanical
properties of a high-Zn aluminum alloy (Al–27Zn–1.5 Mg–1.2 Cu–0.08 Zr) produced by melt …

Undesirable damping capacity and mechanical properties resulted from coarse α-Al
dendrites and network eutectoid structures of high-Zn aluminum casting alloys are the main …

The flake graphite, polytetrafluoroethylene, and molybdenum disulfide (MoS2) filled
phenolic resin‐based composites were prepared by hot press molding. The thermal …

The effect of Ag on the microstructure, mechanical properties, and tribological properties of
Al-33Zn-2Cu alloys was investigated. The results show that the mechanical properties of the …

The wear and sliding friction response of a hybrid copper metal matrix composite reinforced
with 10 wt% of tin (Sn) and soft solid lubricant (1, 5, and 7 wt% of MoS2) fabricated by a …

The effect of aging temperature on the lubricated wear behavior of multi directionally forged
Al-40Zn-3Cu alloy was systematically investigated at different loads and sliding speeds …

The cross accumulative roll bonding (CARB) combined with the heat treatment process was
used to develop high-Zn Al-xZn alloys with 20 and 50 wt% Zn. The effect of the Zn content …