Abstract In the More Electric Aircraft (MEA), many subsystems that previously used hydraulic,
mechanical, and pneumatic power have been fully or partially replaced with electrical …

Electromagnetic interference (EMI) from renewable power systems to the grid attracts more
attention especially in the low-frequency range, due to the low switching frequency of high …

In the first part, this papers proposes a “black box” model for the EMC modelling of a power
converter in the case of an asymmetrical topology due to the conversion structure or …

Black-box modelling approaches, based on suitable sets of measurements at the output
ports of the device, are often exploited for the modelling of power converters to predict their …

In situations where there is ample space, constructing a high-field electromagnetic
environment for radiated susceptibility testing of aircraft equipment can be difficult. This has …

In this paper, the effects of ground return wires and crosstalk in wiring harness during BCI
test are experimentally analyzed. The analysis shows that BCI coupling efficiency is …

Under ideal conditions, the electromagnetic interference experienced by the secondary
circuit is manifested as a common mode. However, due to circuit imbalance, common mode …

Abstract Power Line Communication (PLC) technologies are used in many applications and
offer the advantage of utilizing existing power cables for both power and data transmission …

The common mode (CM) signal appears equally on both lines of a 2-wire cable not
connected to ground. It is expressed mathematically as the average of the two signal …

Electronic Equipment designed to be loaded onto an aircraft must be certified in accordance
with established EMC standards. This paper is focused on section 20 of RTCA-DO160 which …