[HTML][HTML] Effect of precursor concentration on corrosion resistance and microstructure of ZnO thin films using spray pyrolysis method
This paper presents the preparation and characterization of ZnO at various molarities
deposited on glass and 316L stainless steel (316L SS) substrates via spray pyrolysis …
deposited on glass and 316L stainless steel (316L SS) substrates via spray pyrolysis …
Effect of precursor concentration on stoichiometry and optical properties of spray pyrolyzed nanostructured NiO thin films
In this study, spray pyrolysis was used to produce nanostructured NiO thin films from high
purity nickel acetate (Ni (CH 3 COO) 2. 3H 2 O) precursors on pre-heated ultrasonically …
purity nickel acetate (Ni (CH 3 COO) 2. 3H 2 O) precursors on pre-heated ultrasonically …
[HTML][HTML] Enhanced optoelectronic and supercapacitive performance of electrodeposited Mn3O4 thin film prepared from two-electrode: an effect of Zn-ion incorporation
Here in, we report electrodeposited Mn 3 O 4 thin film doped with various level of Zn dopant
(0≤ x≤ 5. 0,%), on a layer of indium tin oxide (ITO) on glass substrate. The deposition route …
(0≤ x≤ 5. 0,%), on a layer of indium tin oxide (ITO) on glass substrate. The deposition route …
Microstructure and anti-corrosion properties of spray pyrolyzed Ni-doped ZnO thin films for multifunctional surface protection applications
The microstructures, electrochemical, and hardness properties of deposited Ni-doped ZnO
thin films on ultrasonically cleaned 316L stainless steel (316L ST) employing a low-cost …
thin films on ultrasonically cleaned 316L stainless steel (316L ST) employing a low-cost …
Effect of tin concentrations on the elemental and optical properties of zinc oxide thin films
AV Babalola, V Oluwasusi, VA Owoeye, JO Emegha… - Heliyon, 2024 - cell.com
Pure zinc oxide and Sn-doped ZnO thin films were deposited on a pre-heated glass
substrate from tin (II) chloride dihydrate (SnCl 2. 2H 2 O) and zinc acetate (Zn (CH 3 COO)) 2 …
substrate from tin (II) chloride dihydrate (SnCl 2. 2H 2 O) and zinc acetate (Zn (CH 3 COO)) 2 …
Response of Various Extrusion Parameters to Different Outputs
Extrusion as a process involves the introduction of compressive force to drive metal sample
out of the die in order to subject it to plastic deformation which in turn will enhance both …
out of the die in order to subject it to plastic deformation which in turn will enhance both …
Experimental and Statistical Analysis of Internally Cured Concrete Pavement under Loading
The conventional approach of external curing is limited as the whole three-dimensional
microstructure of concrete does not cure and saturated. In external curing, only the concrete …
microstructure of concrete does not cure and saturated. In external curing, only the concrete …