Reduced-activation ferritic-martensitic (RAFM) steels, candidate structural materials for
fusion reactors, have achieved technological maturity after about three decades of research …

International development of reduced activation ferritic-martensitic (RAFM) steels has
focused on 9 wt percentage Cr, which primarily contain M 23 C 6 (M= Cr-rich) and small …

Considering that most creep-fatigue tests were conducted under strain-controlled mode in
previous works, creep-fatigue behavior of 9–12% Cr steel under stress-controlled cycling at …

Abstract In this paper, Low Cycle Fatigue (LCF) and Creep-Fatigue Interaction (CFI)
behavior of 9Cr-0.5 Mo-1.8 WV-Nb heat-resistant steel (ASME Grade P92 steel) at elevated …

In this investigation, response of Alloy 617 M to creep-fatigue interaction loading has been
studied. The creep-fatigue interaction tests were conducted in air environment at a constant …

This investigation determined the creep-fatigue cyclic-life (N f) saturation effect for the DZ445
superalloy with 16–128 min dwell time at 900° C and total strain range of 1.6%. When the …

The effect of Zr in the range of 0–∼ 1.36 wt.% on the microstructure and mechanical
properties of 12Cr ferritic/martensitic steels was investigated. The steels were prepared by …

P92 steel has gained plenty of attention as a top contender for steam generator components
and main steam tubes due to the growing need to increase the energy conversion efficiency …

In this paper, post bonding heat treatments to transient liquid phase bond reduced activation
ferrite/martensitic steel were conducted, with a Fe–Si–B amorphous foil as the interlayer …

High total strain-controlled creep-fatigue tests of 1.8% were performed for a directionally-
solidified Ni-based superalloy, DZ445, at 900° C in air. Dwell times of 0, 2, and 5 min. were …