Magnetism and microfluidics
N Pamme - Lab on a Chip, 2006 - pubs.rsc.org
Magnetic forces are now being utilised in an amazing variety of microfluidic applications.
Magnetohydrodynamic flow has been applied to the pumping of fluids through …
Magnetohydrodynamic flow has been applied to the pumping of fluids through …
MEMS inductor fabrication and emerging applications in power electronics and neurotechnologies
MEMS inductors are used in a wide range of applications in micro-and nanotechnology,
including RF MEMS, sensors, power electronics, and Bio-MEMS. Fabrication technologies …
including RF MEMS, sensors, power electronics, and Bio-MEMS. Fabrication technologies …
Planar microcoil-based microfluidic NMR probes
Microfabricated small-volume NMR probes consisting of electroplated planar microcoils
integrated on a glass substrate with etched microfluidic channels are fabricated and tested …
integrated on a glass substrate with etched microfluidic channels are fabricated and tested …
Measuring reaction kinetics in a lab-on-a-chip by microcoil NMR
H Wensink, F Benito-Lopez, DC Hermes, W Verboom… - Lab on a Chip, 2005 - pubs.rsc.org
A microfluidic chip with an integrated planar microcoil was developed for Nuclear Magnetic
Resonance (NMR) spectroscopy on samples with volumes of less than a microliter. Real …
Resonance (NMR) spectroscopy on samples with volumes of less than a microliter. Real …
Experimental and simulation investigations of the impact of polyacrylamide on CBM ad-/desorption
Q Huang, B Wu, Y Liu, Z Guo, G Wang, L Sun - Journal of Petroleum …, 2022 - Elsevier
Slickwater is commonly used during hydraulic fracturing in coalbed gas well, which is often
prepared with polyacrylamide as the friction reducer. To investigate the impact of …
prepared with polyacrylamide as the friction reducer. To investigate the impact of …
A fully MEMS-compatible process for 3D high aspect ratio micro coils obtained with an automatic wire bonder
K Kratt, V Badilita, T Burger, JG Korvink… - Journal of …, 2009 - iopscience.iop.org
We report the fabrication of 3D micro coils made with an automatic wire bonder. Using
standard MEMS processes such as spin coating and UV lithography on silicon and Pyrex® …
standard MEMS processes such as spin coating and UV lithography on silicon and Pyrex® …
Planar microresonators for EPR experiments
R Narkowicz, D Suter, R Stonies - Journal of Magnetic Resonance, 2005 - Elsevier
EPR resonators on the basis of standing-wave cavities are optimised for large samples. For
small samples it is possible to design different resonators that have much better power …
small samples it is possible to design different resonators that have much better power …
In vivo NMR spectroscopy
Understanding biological processes at the molecular level is a pillar of modern science, and
unique insight can be gained by studying living organisms in real time. As a non-destructive …
unique insight can be gained by studying living organisms in real time. As a non-destructive …
Stripline probes for nuclear magnetic resonance
PJM Van Bentum, JWG Janssen, APM Kentgens… - Journal of Magnetic …, 2007 - Elsevier
A novel route towards chip integrated NMR analysis is evaluated. The basic element in the
design is a stripline RF 'coil'which can be defined in a single layer lithographic process and …
design is a stripline RF 'coil'which can be defined in a single layer lithographic process and …
Microscale nuclear magnetic resonance: a tool for soft matter research
Nuclear magnetic resonance spectroscopy (NMR) and imaging (MRI) are important non-
destructive investigative techniques for soft matter research. Continuous advancements …
destructive investigative techniques for soft matter research. Continuous advancements …