As plastic production continues to increase globally, plastic waste accumulates and
degrades into smaller plastic particles. Through chemical and biological processes …

Different nanocomposites have been attained by in situ polymerization based on ultra-high
molecular weight polyethylene (UHMWPE) and mesoporous SBA-15, this silica being used …

The mutual irradiated aramid fibers in 1, 4‐dichlorobutane was ammoniated by
ammonia/alcohol solution, in an attempt to improve the interfacial properties between …

The effect of irradiation by electron beam with dose of 10–80 kGy on the properties of a
number of semicrystalline polymers preliminary subjected to severe plastic deformation …

The article describes the influence of an electron beam irradiation (I), plastic deformation
(D), and re‐irradiation (R) on the properties of ultrahigh molecular weight polyethylene …

Nanoscale polymers (including nanoplastics) are widely present through commerce and
make their way into the environment. As the improper disposal of plastic waste leads to …

W XXI wieku, bardzo częstym kryterium doboru materiału jest jego stosunek masy do
wytrzymałości. Bardzo dużą wagę przywiązuje się również do rozwiązań przyjaznych …

Исследовано влияние облучения электронным пучком дозой 1-8 Мрад на свойства
ряда кристаллизующихся полимеров, предварительно подвергнутых равноканальной …

GUR1020 and GUR1050 polyethylenes, intended for the production of endoprosthesis cups,
were subjected to forming by uniaxial compression (up to the value of plastic deformation …

The paper compares the modification methods of polymers GUR 1050 and GUR 1020 by
means of plastic deformation before (ON) and after (NO) irradiation with an electron beam …