Annealing of RF-magnetron sputtered SnS2 precursors as a new route for single phase SnS thin films
Tin sulphide thin films have been grown on soda-lime glass substrates through the
annealing of RF-magnetron sputtered SnS 2 precursors. Three different approaches to the …
annealing of RF-magnetron sputtered SnS 2 precursors. Three different approaches to the …
Fundamental aspects and comprehensive review on physical properties of chemically grown tin-based binary sulfides
The rapid research progress in tin-based binary sulfides (SnxSy= o-SnS, c-SnS, SnS2, and
Sn2S3) by the solution process has opened a new path not only for photovoltaics to …
Sn2S3) by the solution process has opened a new path not only for photovoltaics to …
Co-evaporated SnS thin films for visible light photodetector applications
SnS thin films with different thicknesses have been deposited on glass substrates at a
substrate temperature of 300° C. The influence of thickness on structural, morphological …
substrate temperature of 300° C. The influence of thickness on structural, morphological …
SnS-based thin film solar cells: perspectives over the last 25 years
JA Andrade-Arvizu, M Courel-Piedrahita… - Journal of Materials …, 2015 - Springer
New types of thin film solar cells made from earth-abundant, non-toxic materials and with
adequate physical properties such as band-gap energy, large absorption coefficient and p …
adequate physical properties such as band-gap energy, large absorption coefficient and p …
A highly sensitive flexible SnS thin film photodetector in the ultraviolet to near infrared prepared by chemical bath deposition
MS Mahdi, K Ibrahim, A Hmood, NM Ahmed… - RSC …, 2016 - pubs.rsc.org
This study involves a novel fabrication of a high performance, low cost and flexible (SnS
nanoflake based) photodetector on a polyethylene terephthalate (PET) substrate by using …
nanoflake based) photodetector on a polyethylene terephthalate (PET) substrate by using …
Preparation and properties of zinc blende and orthorhombic SnS films by chemical bath deposition
C Gao, H Shen, L Sun - Applied Surface Science, 2011 - Elsevier
SnS (stannous sulfide) films were prepared by chemical bath deposition in which a novel
chelating reagent ammonium citrate was used. The film has a zinc blende structure or an …
chelating reagent ammonium citrate was used. The film has a zinc blende structure or an …
[PDF][PDF] Properties of p-type SnS thin films prepared by chemical bath deposition
In recent years, thin films of SnS have attracted much attention for the photovoltaic
applications due to the high absorption coefficient (≈ 104cm-1 near the fundamental …
applications due to the high absorption coefficient (≈ 104cm-1 near the fundamental …
CZTS solar cell with non-toxic buffer layer: A study on the sulphurization temperature and absorber layer thickness
P Prabeesh, VG Sajeesh, IP Selvam, MSD Bharati… - Solar Energy, 2020 - Elsevier
Cu 2 ZnSnS 4 solar cell has been fabricated with a non-toxic buffer layer and Al doped ZnO
transparent conducting layer. A detailed material study on each layer of the solar cell has …
transparent conducting layer. A detailed material study on each layer of the solar cell has …
Effect of Sb dopant on the structural, optical and electrical properties of SnS thin films by spray pyrolysis technique
KS Kumar, C Manoharan, S Dhanapandian… - … Acta Part A: Molecular …, 2013 - Elsevier
Thin films of antimony doped tin sulphide (SnS: Sb) with different antimony concentrations
have been prepared by the spray pyrolysis technique at the substrate temperature of 350° C …
have been prepared by the spray pyrolysis technique at the substrate temperature of 350° C …
A new nanocrystalline binary phase: synthesis and properties of cubic tin monoselenide
A new nanometric cubic binary phase of the tin mono-selenide system, π-SnSe, was
obtained as cube shaped nanoparticles. Its structure and atomic positions were adopted …
obtained as cube shaped nanoparticles. Its structure and atomic positions were adopted …