Abstract Outdoor applications of Al–Mg–Si alloys have been specified due to their very good
corrosion resistance when compared with those of other aluminum alloys. Nevertheless …

The effect of repeated heat-treatment (HT) cycles, as precisely applied in the regular dental
practice to produce metal-ceramic restorations, on microstructure, mechanical properties …

The effect of holding time, thickness and annealing heat treatment on the microstructure and
some mechanical properties of compacted graphite iron (CGI) are studied. Samples of CGI …

Abstract An Al-5Mg alloy (AA5083) block, deposited over an AA6061 substrate by wire-arc
additive manufacturing, was electrochemically tested along two different cross-sectional …

High-entropy alloys are interesting for both aerospace and biomedical applications.
Additionally, their application into a corrosive environment is also demanded. Investigations …

This investigation is focused on the corrosion evaluation of an as-cast Al-7.5 wt% Si alloy
and an Al/7.5 wt% Si composite immersed into distinctive biofuels. Immersions up to~ 6000 …

Abstract Corrosion behaviors of Al-15% Mg 2 Si-1% Ni alloy in 3.5% NaCl solution were
studied by characterizing the corrosion morphologies of Al 3 Ni, Mg 2 Si, and Al phases. The …

Electrochemical and corrosion behaviour of as-cast NixAly intermetallic alloys (Ni25Al75,
Ni40Al60, Ni50Al50 and Ni75Al25 in at.%) is investigated and compared with commercially …

Al-matrix composites, ex situ reinforced with WC nanoparticles and in situ reinforced with Al
3 (Ti, W), Al 12 W, Al 5 W and Al 4 W, have been fabricated by casting assisted by K 2 TiF 6 …

The corrosion behavior of 2099 Al–Li alloy in NaCl aqueous solutions with different
concentrations (1.5, 3.5, and 5.0% in mass fraction) was investigated. Its corrosion …