We study the effects of dilute Mg addition on the microstructure formation and mechanical
properties of a ZnAl4Cu1 alloy. On the basis of the composition of the commercial alloy Z410 …

In this investigation, the effect of manganese as an alloying element in the range 0.01%–
0.53 wt.%, on the hardness, 0.2% yield, tensile and impact strength, and creep properties of …

Tensile properties and impact toughness of the severe plastically deformed Zn–40Al alloy
were investigated. The material billets were subjected to equal-channel angular extrusion …

In this study, plasma electrolytic oxidation (PEO) was successfully applied on a ZA27 alloy to
produce continuous and dense ceramic coatings. The effects of the electrolytes (silicate …

In this paper, a continuous and dense coating was deposited on samples of the ZA27 alloy
through the plasma electrolytic oxidation (PEO) process to improve its wear and corrosion …

The microstructural evolution, tensile response and wear properties of a two-phase Zn–Al
alloy (Zn-8 wt.% Al, ZA-8) have been studied after severe plastic deformation by equal …

A two-phase zinc–aluminum alloy (Zn–8wt.% Al) has been subjected to severe plastic
deformation via equal channel angular extrusion (ECAE). The alloy was successfully …

In this study, the effect of Ti–B (0.05–0.7 wt.% Ti, 0.01–0.13 wt.% B) and Sr additions (0.05–
0.7 wt.%) on the hardness, ultimate tensile strength (UTS), strain and fatigue properties of …

The effect of V alloying on the creep properties of the Zn-10Al alloy at ambient temperature
was investigated. V alloying significantly refined the Zn-10Al grains, and a new Al 3 V phase …

Hexagonal closed packed (hcp) materials, in contrast to cubic materials, possess several
processing challenges due to their anisotropic structural response, the wide variety of …