Computational Fluid Dynamics is one of the most relied upon tools in the design and
analysis of components in turbomachines. From the propulsion fan at the inlet, through the …

The need for non-destructive testing/structural health monitoring (SHM) is becoming
increasingly important for gas turbine manufacturers. Incipient cracks have to be detected …

For the nonlinear dynamic analyses of complex mechanical components, it is necessary to
apply efficient modeling framework to reduce computational burden. The accurate surrogate …

The accurate monitoring of blade vibration under operating conditions is essential in turbo-
machinery testing. Blade tip timing (BTT) is a promising non-contact technique for the …

Blade tip clearance is one of the important parameters affecting the performance, safety and
stability of a gas turbine engine. However, it is difficult to measure the tip clearance in real …

Assembly analysis is necessary for mechanical product to optimize design and improve the
product quality since assembly deviation is the key factor affecting the assembly quality. In …

A passive balancing device is a bearing with a set of masses that are free to move about a
shaft axis of rotation. Beyond the first critical speed of the shaft, the masses assume …

The quantitative analysis of the uncertainty influence on thermodynamic parameters and
performance parameters is usually difficult to achieve due to the strong nonlinear working …

Peak height detection is critical for blade tip clearance (BTC) measurement based on
capacitive probes. However, the noise interference of the complicated working environments …

An analysis of compressor rotor tip clearance measurements using capacitance probe
instrumentation is discussed for a three‐stage axial compressor. Thermal variations and …