Buildings are responsible for over 30% of global final energy consumption and nearly 40%
of total CO2 emissions. Thus, rapid penetration of renewable energy technologies (RETs) in …

Municipal solid waste (MSW) is increasingly considered a source of energy and materials
rather than an environmental and socioeconomic problem. Incineration using the grate-firing …

The article presents the results of RDF (Refuse Derived Fuel) examination in order to use it
for energy purpose. RDF material was subjected to thermogravimetric analysis. The TGA …

The reduction of NO x (nitrogen oxides) emission remains the key challenge in the
incineration of MSW (municipal solid waste). The flame position, gas temperature and heat …

There can be observed global interest in waste pyrolysis technology due to low costs and
availability of raw materials. At the same time, there is a literature gap in forecasting …

Air preheating is generally used to improve moisture evaporation and boiler efficiency in
waste incineration systems. This study employs FLIC-FLUENT coupling procedure to …

The simulations of combustion and NO X emissions process are conducted by
computational fluid dynamics method with comprehensive physical and chemical models in …

For first time in literature, a dynamic process simulation model of a municipal solid waste
incinerator is generated. The developed model of the 60 MW th incinerator describes in …

Among the sustainable ways of municipal solid waste management (MSW) is energy
recovery, particularly into refuse derived fuel (RDF). However, the potential, application, and …

The co-incineration of multisource organic solid waste has gradually become an important
method for solid waste recycling. Through a combination of computational fluid dynamics …