Al–Si alloys with silicon content more than 13% are termed as hypereutectic alloys. In recent
years, these alloys have drawn the attention of researchers due to their ability to replace cast …

The influence of Ti addition (up to 4wt.%) on wear behavior of as-cast and heat-treated Al–
12wt.% Si eutectic alloy prepared by rapid cooling has been investigated in dry sliding …

In this study, the effect of Si addition up to 8% Si on the abrasive wear and mechanical
properties of Al–Si/60vol.% SiC composites produced by pressure infiltration technique has …

Abstract Hypereutectic Al–x% Si–0.8 Sc alloys (x= 13, 16, 19 and 22 wt%) were produced by
spray forming. The microstructures of all the alloys exhibited very fine silicon phase with …

In the present study, Al–Si alloys with Si contents of 23, 26, 28 and 31 wt.%, respectively,
were modified with a new modifying agent. The results show that the primary silicon size …

A study has been conducted to investigate the mechanical and wear behaviors of the Al–
12Si–XMg alloys (where Mg contents were 5%, 10% and 20%) cast by adding modifiers …

In this study the mechanical behaviours of Al–12Si–XMg alloys (where Mg contents varied
up to 20%) have been investigated. The alloys were prepared by casting followed by …

In the present work, Al–30Mg2Si–2Cu alloy has been spray formed and subsequently hot
pressed for densification. The alloy is then subjected to solutionizing and isothermal aging …

In this study, mechanical and tribological properties of multi-directional hot forged Al-7Si-4Zn-
3Cu alloy at different cycles were investigated. Multi-directional hot forging resulted in both …

Aluminum and its alloys are normally grain refined by Ti or Ti+ B to transfer their columnar
structure during solidification into equiaxed one which improves their mechanical behavior …