Hot tensile experiments of a Ti-6Al-4V alloy with coarse equiaxed phases are implemented
at the temperatures of 800–900° C and strain rates of 0.0005–0.005 s− 1. All the flow stress …

The dynamic recrystallization (DRX) behavior of a typical nickel-based superalloy is
investigated by the hot compression tests. Based on the conventional DRX kinetics model …

The dynamic recrystallization behavior in 42CrMo steel was investigated by hot
compression tests. The effects of deformation temperature, strain rate, and initial austenite …

Uniaxial tensile tests of a typical Ni-based superalloy are conducted under the deformation
temperature range of 920–1010° C and strain rate range of 0.01–0.001 s− 1. The effects of …

Slip is the main plastic deformation mechanism in titanium alloys at room temperature. This
is especially so for near alpha titanium alloy like Ti–6Al–2Zr–1Mo–1V, which contains low …

In this work, the hot deformation behaviors of Udimet 720Li superalloy with the
microstructures of coarse grain, fine grain and mixed grain were studied contrastively by …

The isothermal tensile deformation behaviors of Ti-5Al-5Mo-5V-1Cr-1 Fe alloy in β phase
field are studied at the wide ranges of temperature and strain rate. The experimental results …

Flow softening and ductile damage behavior of TA15 titanium alloy with initial bimodal
microstructure were studied using uniaxial hot tensile tests at different temperatures (750 …

The hot flow behavior, spheroidization, dynamic recrystallization (DRX) and fusing of
lamellar ɑ phase for hot isostatic pressed Ti–6Al–4V titanium alloy was investigated at 950° …

A set of constitutive equations coupling microstructure evolution have been developed for
hot working of a TA15 titanium alloy. Physically-based microstructure models were …