Abstract Trace amount of Sr (0.05 wt.%) was added into the hypoeutectic Al− Si (3− 12 wt.%
Si) alloys to modify their microstructure and improve thermal conductivity. The results …

In this paper, a new type of Al-8Si-1.5 Cu-1Ni-0.5 Mg-0.5 Mn-0.2 Ti-0.2 Zr-0.2 V-0.06 Sr alloy
(Al-Si-Cu-Ni alloy for short) was prepared by combining micro-alloying and squeeze casting …

The effect of Zn addition on microstructure and corrosion behavior of Al-6Si-3Cu alloy are
investigated. The addition of Zn improves the corrosion resistance of T6-treated Al-6Si-3Cu …

压铸铝合金研究现状与未来发展趋势 Page 1 压力铸造 2020年 第2期/第69卷 159 压铸铝合金
研究现状与未来发展趋势 樊振中1,2,袁文全3,王端志3,董春雨4,杨 欢4,陈军洲1,2 (1. 中国航发 …

The microstructures and corrosion resistances of hypoeutectic Al-6.5 Si-0.45 Mg casting
alloys with addition of both Sc and Zr were investigated by using scanning electron …

The effect of casting method and alloy modification on secondary dendrite arm spacing
(SDAS) and eutectic Si size of Al-Si binary alloy was investigated. For this, the Al-5Si binary …

The casting process, the type and content of microalloying elements have a significant effect
on the microstructure and mechanical properties of Al–12Si-4.5 Cu–2Ni alloy. The results …

The influence of B and Sb on the microstructure and corrosion behavior of T6-treated Al–Si–
Mg alloys has been specifically studied. It is found that the addition of 0.03 wt% B to Al–Si …

The effects of Zn content on strength and wear performance of Al− 12Si− 3Cu alloy
synthesized by gravity casting were systematically investigated. The microstructure and …

High-pressure die-casting (HPDC) was used to develop two sizes of Al− 7Si− 0.2 Mg (mass
fraction,%) thin-plates with similar composition. Thin-plate castings with varying degrees of …