Scale-up of pharmaceutical spray drying using scale-up rules: A review

S Poozesh, E Bilgili - International Journal of Pharmaceutics, 2019 - Elsevier
Spray drying is one of the widely used manufacturing processes in pharmaceutical industry.
While there are voluminous experimental studies pertaining to the impact of various process …

Pyrometallurgical processing of ferrous slag “co-product” zero waste full utilization: A critical review

J Yang, F Firsbach, I Sohn - Resources, Conservation and Recycling, 2022 - Elsevier
The inherent occurrence of slag" co-products" and its utilization during ferrous production
are crucial for the industry to ensure greater sustainability. In this work, various research and …

Optimization of painting efficiency applying unique techniques of high-voltage conductors and nitrotherm spray: Developing deep learning models using …

MR Pendar, S Cândido, JC Páscoa - Physics of Fluids, 2023 - pubs.aip.org
The impetus of the current three-dimensional Eulerian–Lagrangian work is to analyze the
impact of simultaneously using the inventive highvoltage conductors and Nitrotherm …

Review of coating and curing processes: Evaluation in automotive industry

MR Pendar, F Rodrigues, JC Páscoa, R Lima - Physics of Fluids, 2022 - pubs.aip.org
The paint shop plant, as the largest energy consumer in the automotive manufacturing
process, requires special attention to optimize energy efficiency and thermal management …

Research status of centrifugal granulation, physical heat recovery and resource utilization of blast furnace slags

YH Feng, Z Zhang, J Gao, GP Feng, L Qiu… - Journal of Analytical and …, 2021 - Elsevier
The molten blast furnace slags, a kind of main by-product in Iron and Steel industry, contains
a substantial amount of high-grade thermal energy and untapped resources, and thus their …

Investigation of capillary wave, cavitation and droplet diameter distribution during ultrasonic atomization

Y Zhang, S Yuan, L Wang - Experimental Thermal and Fluid Science, 2021 - Elsevier
Droplet size distribution during ultrasonic atomization was investigated by laser diffraction
based on two phenomena—capillary waves and cavitation. The former was visually …

Numerical analysis of charged droplets size distribution in the electrostatic coating process: Effect of different operational conditions

MR Pendar, JC Páscoa - Physics of Fluids, 2021 - pubs.aip.org
This paper presents a numerical performance evaluation of the electrostatic rotary bell
sprayer (ERBS) with a particular focus on droplet charge, electric field, and ambient …

Centrifugal granulation performance of liquid with various viscosities for heat recovery of blast furnace slag

JJ Wu, H Wang, X Zhu, Q Liao, B Ding - Applied Thermal Engineering, 2015 - Elsevier
Centrifugal granulation is a crucial step in the most promising heat recovery technique for
molten blast furnace slag. Facing the fact that slag viscosity changes during the granulation …

Modeling and experimental studies of mass transfer in the cavity zone of a rotating packed bed

L Sang, Y Luo, GW Chu, YZ Liu, XZ Liu… - Chemical Engineering …, 2017 - Elsevier
A rotating packed bed (RPB), which creates a high gravity environment by the centrifugal
force, is one of the typical process intensification equipment. The cavity zone is an important …

Simulation of ligament mode breakup of molten slag by spinning disk in the dry granulation process

D Wang, X Ling, H Peng - Applied Thermal Engineering, 2015 - Elsevier
This paper performed the numerical investigations on the physical mechanism of ligament
mode breakup of molten slag at the spinning disk edge by volume of fluid methodology, the …