SAW-less analog front-end receivers for TDD and FDD

I Fabiano, M Sosio, A Liscidini… - IEEE Journal of Solid …, 2013 - ieeexplore.ieee.org
A multistandard SAW-less receiver is designed exploring a current-mode architecture. A
class-AB common-gate transformer-based low-noise transconductor amplifier (LNTA) is …

Analysis and design of a high-order discrete-time passive IIR low-pass filter

M Tohidian, I Madadi… - IEEE Journal of Solid …, 2014 - ieeexplore.ieee.org
In this paper, we propose a discrete-time IIR low-pass filter that achieves a high-order of
filtering through a charge-sharing rotation. Its sampling rate is then multiplied through …

A 0.46-mm 4-dB NF Unified Receiver Front-End for Full-Band Mobile TV in 65-nm CMOS

PI Mak, RP Martins - IEEE Journal of Solid-State Circuits, 2011 - ieeexplore.ieee.org
A unified receiver front-end (RFE) for mobile TV covering the VHF-III, UHF and L bands is
described. Performance, power and area efficiencies are advanced in threefold: 1) a gain …

A 2.4-GHz ZigBee receiver exploiting an RF-to-BB-current-reuse Blixer+ hybrid filter topology in 65-nm CMOS

Z Lin, PI Mak, RP Martins, Z Lin, PI Mak… - Ultra-Low-Power and …, 2016 - Springer
A 2.4-GHz ZigBee Receiver Exploiting an RF-to-BB-Current-Reuse Blixer + Hybrid Filter
Topology in 65-nm CMOS | SpringerLink Skip to main content Advertisement SpringerLink …

An RF-to-BB-current-reuse wideband receiver with parallel N-path active/passive mixers and a single-MOS pole-zero LPF

F Lin, PI Mak, RP Martins - IEEE Journal of Solid-State Circuits, 2014 - ieeexplore.ieee.org
N-path passive-mixer-first receivers suffer from a tight tradeoff between noise figure (NF),
linearity and power due to no RF gain. This paper describes an extensively-current-reuse …

Tunable class AB CMOS Gm-C filter based on quasi-floating gate techniques

C Garcia-Alberdi, AJ Lopez-Martin… - … on Circuits and …, 2012 - ieeexplore.ieee.org
A tunable CMOS Gm-C channel-select low-pass filter is presented. Class AB operation
overcomes the dynamic range versus static power tradeoff of conventional channel-select …

A 0.49–13.3 MHz tunable fourth-order LPF with complex poles achieving 28.7 dBm OIP3

P Payandehnia, H Maghami, H Mirzaie… - … on Circuits and …, 2018 - ieeexplore.ieee.org
A novel switched-capacitor low-pass filter architecture is presented. In the proposed
scheme, a feedback path is added to a charge-rotating real-pole filter to implement complex …

A 63-dB DR 22.5-MHz 21.5-dBm IIP3 fourth-order FLFB analog filter

M De Matteis, A Pipino, F Resta… - IEEE Journal of Solid …, 2017 - ieeexplore.ieee.org
In this paper, a fourth-order continuous-time follow-the-leader-feedback (FLFB) low-pass
(LP) filter is presented. The outstanding FLFB noise behavior is exploited to minimize power …

Analysis and design of a 20-MHz bandwidth, 50.5-dBm OOB-IIP3, and 5.4-mW TIA for SAW-less receivers

G Pini, D Manstretta, R Castello - IEEE Journal of Solid-State …, 2018 - ieeexplore.ieee.org
A power-efficient transimpedance amplifier with wide channel bandwidth is proposed to
meet the stringent linearity requirements of surface acoustic wave-less frequency-division …

A filtering ΔΣ ADC for LTE and beyond

M Andersson, M Anderson, L Sundström… - IEEE Journal of Solid …, 2014 - ieeexplore.ieee.org
This paper presents a filtering ADC for the LTE communication standard, where a second-
order Delta-Sigma modulator (DSM) is incorporated into the third-order Chebyshev channel …