The gas tungsten arc welding (GTAW) was employed to weld dissimilar materials of 304L
austenitic stainless steel (ASS) and Ti-stabilized 439 ferritic stainless steel (FSS). Dissimilar …

Super duplex stainless steel UNS S32750 is widely used in marine industries, pulp and
paper industries, and the offshore oil and gas industry. Welding manufacturing is one of the …

UNS S32101 lean duplex stainless steel (DSS) has a two phase microstructure consisting of
austenite and ferrite in near equal proportions. Aging at high temperature results in …

In the present work, the effect of post weld heat treatment (PWHT) on the microstructure and
micro-texture evolution in 316L austenitic stainless steel (ASS)/2205 duplex stainless steel …

In the present work, the effect of long-term aging at 750° C up to 480 h on microstructure
evolution, texture development and corrosion behavior of a low molybdenum Fe–21Cr-1.5 …

The thin-wall specimens of ER2594 duplex stainless steel (DSS) were prepared by metal
electrode inert gas shielded arc welding (MIG). It is found that the duplex stainless steel …

In this research, the microstructure of three melt‐spinning ribbons with a weight‐based
composition of Fe–25Cr–5Ni and varying carbon contents (0.02, 0.10, and 0.38 wt%) is …

The investigation focuses on the microstructure, impact toughness, and pitting corrosion
resistance of cold metal transfer and pulse hybrid welded joints of unified numbering system …

Improved formability is observed in incremental sheet forming (ISF) than conventional sheet
metal forming operations due to the acquisition of the higher limiting strain. Texture …

Additive manufacturing (AM), also known as rapid prototyping or 3D printing technique, has
been continuously improving day by day, which has led to an increase in its application in a …