In this paper, investigating the influence of wear properties such as load, distance, and
sliding speed are analyzed to statistical behavior of the wear mass loss and co efficient of …

The influence of Cr-Al-Si-N, DLC-Si, and Cr-Al-Si-N/DLC-Si thin coatings deposited on
titanium alloy (Ti-Al-Zr-Sn-Nb system) samples with different surface reliefs on wear …

This chapter looks at physical vapor deposition (PVD) processes currently used for wear
protectors, including coating of ALTIN/DLC/TIALN, TIN, and so on. It also addresses the …

Abstract Wire Electrical Discharge Machine (WEDM) is a non-conventional machining
process for machining electrically conductive materials regardless of their hardness …

An attempt was taken to study the wear rate of coated Inconel 625 using 0.3 gm of multiwall
carbon tubes (MWCNT). The coating was carried out by the Ni‐P electroless coating …

Grey cast iron (GCI) and steel contact surface application is an inevitable component and
provides good wear resistance in several applications, not only in automobiles. Grey cast …

This research investigates the tribological behavior of gray cast iron against EN31 steel
under lubricated conditions. The most typical lubricated sliding phenomena are the …

The effect of thermal cycling on tensile properties and microstructural characterization of
Titanium (Ti–6Al–4V) alloy which were subjected to various types of thermomechanical …

In medical science, there is a growing need for transplants of organs as organ donations are
stagnated with long waiting time, while the condition of the sufferers is deteriorating and …

Punches and dies are cutting tools used to make holes on metallic surfaces using the punch
which passes through the work into a die. Today's tool/die machinists and buyers need to …