The deposition of a thin (several tens of microns) protective coating in atmospheric
conditions is a challenging task for surface engineering. The structural features and …

Pulsed plasma treatment was applied for surface modification and laminated coating
deposition on 14.5 wt%-Cr cast iron. The scopes of the research were:(a) to obtain a …

Pulsed plasma treatment (PPT) is becoming widely used for the surface hardening of
machine parts and tools [1-3]. There are numerous works by Yu. Tyurin, A. Pogrebnyak et …

The structural and tribological properties of a protective high-chromium coating synthesized
on gray cast iron by air pulse-plasma treatments were investigated. The coating was …

This paper presents the pulse electrothermal plasma accelerator erosion type. Formation of
dense plasma bunches occurs under atmospheric pressure through the development of …

The possibility of the pulsed electrothermal plasma accelerator application was shown for
some technological problems. In particularly it was demonstrated the possibility to produce …

The kinetics of the change in the microstructure and hardness of the coating obtained by
pulse-plasma deposition of 28% Cr cast iron during consequent heat treatment was …

Цель. В данной научной работе необходимо провести исследование композиционного
покрытия, полученного импульсно-плазменной обработкой с применением катодов из …

В статье представлен анализ влияния режимов импульсно-плазменной обработки на
особенности формирования микроструктуры и твердость поверхности чугуна с …

Исследовано строение и распределение химических элементов в покрытии,
полученном на высокохромистом чугуне плазменной обработкой с применением …