The effect of annealing on the tribological and corrosion properties of Al–12Si samples
produced by selective laser melting (SLM) is evaluated via sliding and fretting wear tests …

Abstract Hypereutectic Al–x% Si–0.8 Sc alloys (x= 13, 16, 19 and 22 wt%) were produced by
spray forming. The microstructures of all the alloys exhibited very fine silicon phase with …

Due to light weight, high specific strength, high corrosion resistance and good heat transfer
ability, aluminium alloys are becoming attractive for critical structural applications. These …

An aluminum high silicon alloy coating with the composition of AlSi30Cu5 was prepared by
the plasma spraying technology, and the coating was remelted by laser remelting process …

A comprehensive study on the formation mechanism of supersonic atmospheric plasma
sprayed hypereutectic Al-25 wt% Si coating was performed by investigating microstructural …

The present paper reports the results of the comparative study of mechanical properties of
sintered disperse-strengthened Al–40Sn alloy depending on the method of reinforcing …

Due to their light weight, high corrosion resistance and good heat conductivity, aluminium
alloys are used in many industries today. They are suitable for manufacturing many …

Wear behavior of spray formed Al-Si-Pb alloys was investigated using a pin on disk type
wear testing machine. Wear rate behavior with applied load was observed to depict three …

Al–20Si alloy was subjected to friction stir processing to find its effect on the microstructure
and wear behaviour. The microstructures of as-cast and friction stir processed (FSP) alloy …

This paper presents the study of the microstructure, wear properties of spray-deposited and
hot compressed Al-35Si and Al-45Si alloys. The microstructure analysis and wear …