Sliding bearings are critical components of the internal combustion engine. Friction and
wear occur in the contact area between the shaft and the bearing. Significant wear can occur …

In the past few years, the need for low-cost, high-performance materials is increasing.
Design engineers and researchers are replacing the metals and alloys with advanced …

To improve tribological properties of Babbitt alloys, multi-layer surface texture consisted of
the main grooves and secondary micro-dimples are fabricated on the Babbitt substrate …

Crack-free and uniform nickel–tungsten (NiW) coatings and their composite coatings filled
with ceramic particles such as silicon carbide (SiC) and hexagonal-boron nitride (hBN) were …

Brass and especially bronze in copper based alloys are widely used as journal bearing
material. Pure copper materials are not used as journal bearing material due to their low …

To improve the tribological properties of Babbitt alloy used as journal bearing pad
specifically under severe condition, Babbitt substrate was prayed with a coating of …

The tribological behaviors of Babbitt alloy 16-16-2 sliding against aluminum bronze
ZCuAl9Mn2 lubricated by sea water were systematically investigated in this paper. The …

The friction and wear behavior of journal bearing material has been investigated using pin
on disc wear tester with three different lubricating oils ie synthetic lubricating oil …

This paper discusses the results of a study to determine the effect of the chemical
composition of two tin-based bearing alloys (B89 and B83) on their tribological properties …

Abstract The microstructure of Sn-11Sb-6Cu Babbitt consists of a soft solution matrix and
hard particles (SnSb and Cu 6 Sn 5). The soft solution matrix acts as solid lubrication and …