Stereolithography additive manufacturing (SLAM) has exhibited great potential for
fabricating advanced ceramic objects with geometrically complicated structures for use in …

Nanoporous materials are categorized as microporous (pore sizes 0.2–2 nm), mesoporous
(pore sizes 2–50 nm), and macroporous (pore sizes 50–1000 nm). Mesoporous silica (MS) …

Objective The aim of the study was to evaluate the influence of surface polishing and
printing layer orientation on the fatigue behaviour of 3 mol% yttria-stabilized zirconia (3Y …

A study was conducted to explore the potential of 5 mol% yttria-partially stabilized zirconia
(5Y-PSZ) ceramics for dental restorations, using stereolithography (SLA) printing technique …

This paper aims to fabricate functionally graded dental crown using a multi-slurry tape
casting additive manufacturing technology. The different luminescence of the dental crown …

Objectives This study aimed to determine the crystalline phase composition of 3–6 mol%
yttria-stabilized zirconia (3–6YSZ), specifically investigating the presence of tetragonal (t) …

This study investigated the effect of copper oxide addition on the alumina toughened
zirconia composite ceramic using microwave sintering. CuO amounts (0.05–1 wt%) were …

The aim is to investigate the impact of phase contents on mechanical properties,
translucency, and aging stability of additively manufactured yttria partially stabilized zirconia …

Binder Jetting (BJ) technology, known for its cost-effectiveness and efficiency, is widely used
for the rapid fabrication of complex ceramic cores. However, fabricating high-strength and …

Ceramic vat photopolymerization (VPP) enables the fabrication of complex components with
excellent properties and high precision. However, compared with metals and polymers, the …