A review on wood machining: characterization, optimization, and monitoring of the sawing process
Sawing is the most common machining process and is present in both primary and
secondary wood transformation sectors. The objective of this paper is to review how it is …
secondary wood transformation sectors. The objective of this paper is to review how it is …
Modes of failure of cemented tungsten carbide tool bits (WC/Co): A study of wear parts
Cemented tungsten carbide (WC/Co) holds a successful past as abrasion and wear-
resistant components in mining industries for their wonderful combination of very high …
resistant components in mining industries for their wonderful combination of very high …
Cutting tool temperature monitoring in circular sawing: Measurement and multi-sensor feature fusion-based prediction
In this study, contact thermocouple temperature measurements were used in the wood
circular sawing process, and the saw temperature was monitored at two locations—one …
circular sawing process, and the saw temperature was monitored at two locations—one …
Measurement and analysis of thrust force in drilling of particle board (PB) composite panels
Particleboard is a wood based composite extensively used in wood working. Drilling is the
most commonly used machining process in furniture industries. The surface characteristics …
most commonly used machining process in furniture industries. The surface characteristics …
Properties of WCCo composites produced by the SPS method intended for cutting tools for machining of wood-based materials
J Wachowicz, T Dembiczak, G Stradomski, Z Bałaga… - Materials, 2021 - mdpi.com
This paper presents the possibility of using the Spark Plasma Sintering (SPS) method to
obtain WCCo composite materials. Such materials are used as cutting blades for machining …
obtain WCCo composite materials. Such materials are used as cutting blades for machining …
A comparative study of nanolaminate CrN/Mo2N and CrN/W2N as hard and corrosion resistant coatings
M Beltrami, A Mavrič, S Dal Zilio, M Fanetti… - Surface and Coatings …, 2023 - Elsevier
Nanolaminate coatings (NLC) consisting of alternated CrN coupled with either cubic
tungsten nitride (β-W 2 N) or molybdenum nitride (γ-Mo 2 N) were deposited on cold worked …
tungsten nitride (β-W 2 N) or molybdenum nitride (γ-Mo 2 N) were deposited on cold worked …
Investigation of the effect of process parameters on surface roughness in drilling of particleboard composite panels using adaptive neuro fuzzy inference system
Particleboard wood composites are immensely used for many general and manufacturing
applications. In this study, an analysis of various machining conditions has been performed …
applications. In this study, an analysis of various machining conditions has been performed …
Effect of nitrogen ion implantation on the life time of WC-Co tools used in particleboard milling
This work explores an effect of nitrogen ion implantation on the life time of WC-Co tools used
in particleboard milling. Nitrogen ions with different energy of 5, 50, and 500 keV and …
in particleboard milling. Nitrogen ions with different energy of 5, 50, and 500 keV and …
A review of the use of cryogenic coolant during machining titanium alloys
Titanium alloys are considered difficult-to-machine materials, and much effort has been
made to improve their machinability through various approaches. The use of cryogenic …
made to improve their machinability through various approaches. The use of cryogenic …
Tribological behavior and wear mechanism of pure WC at wide range temperature from 25 to 800° C in vacuum and air environment
Y Liu, Z Wang, Q Sun, B Yin, J Cheng, S Zhu… - International Journal of …, 2018 - Elsevier
The tribological behavior and wear mechanism of pure tungsten carbide (WC) is researched
in this study. In order to simulate the actual work condition, the experimental temperature …
in this study. In order to simulate the actual work condition, the experimental temperature …