The qualities of injection-molded parts are affected by process parameters. Warpage and
volume shrinkage are two typical defects. Moreover, insufficient or excessively large …

Design and manufacturing are the key steps in the sustainable manufacturing of any product
to be produced. Within the perspective of injection molds production, increased …

The present automobile industry has seen a meteoric rise in the use of plastic. In the
automobile sector, this trend toward more complicated parts as a replacement for heavier …

This paper provides overview on suitability of manufacturing chain links by injection molding
process rather than a combination of metal forming operationsas well as selection of …

Flow analysis of three plate family injection mould using pin point gate that consist of four
cavities was studied. The responses investigated were volumetric shrinkage, in-cavity …

Any new material needs to be characterized by mechanical, electrical, thermal and chemical
properties. Filled polymers, which belong to composite materials category, are difficult to …

The high-performance plastics usage is increasing in the automobile field because of its
advantages over other metals and alloys. Corrosion resistance, light weight, low cost …

Shrinkage is a defect in the form of a change in the dimensions of the product as a result of
the injection molding process. Cooling mold is one of the factors that influence shrinkage …

“METODOLOGÍA DE PROTOTIPADO VIRTUAL EN EL DISEÑO Y MANUFACTURA DE MOLDES
DE INYECCIÓN DE PLÁSTICOS” Page 1 DIVISIÓN DE ESTUDIOS DE POSGRADO E …