Fused deposition modelling (FDM) is considered the most popular technique of three-
dimensional (3D) printing. This is a simple and sustainable method of materials …

Reinforcing polymers with particles and fibers has been a common strategy for decades, in
order to make them suitable for high‐demanding industrial applications. As composites often …

Millions of tonnes of glass wastes are produced worldwide, but only marginal is fed back into
recycling with majority ending at stockpiles. Though glass wastes are used in the …

This review article considers published evidence regarding effects of particle size on
mechanical properties of plastic matrix materials filled with cellulose-based reinforcements …

Pore colmatation plays a positive role, since the decrease in the permeability of cement
concrete due to the deposition of insoluble corrosion products in the pores leads to a …

Cotton gin trash (CGT), a potential lignocellulose resource was combined with poly (vinyl
alcohol)(PVA) to produce the biodegradable composite plastic film. A 50: 50 CGT/PVA ratio …

In recent years, developments of hybrid polymer composites by adding the natural and
synthetic resources as reinforcement materials are significantly increased to enhance the …

Influence of size classification on the properties of cellulose materials has been a subject of
neglect over the years. Researchers had the opinion that there exist no significant difference …

Purpose This study aims to investigate the tensile strength and elastic modulus of custom-
designed polymer composites developed using voxel-based design. This study also …

In this study, waste shells of African giant snail (Achatina achatina L.) were explored as
candidates for asbestos-free non-carcinogenic brake pads. The results obtained showed …