Microwave (MW) dielectric ceramics are used in numerous electronic components for
modern wireless communication systems, including antennas, resonators, capacitors and …

Dense microwave dielectric ceramics of Ce2 [Zr1− x (Al1/2Ta1/2) x] 3 (MoO4) 9 (CZMAT)(x=
0.02–0.10) were prepared by the conventional solid-state route. The effects of (Al1/2Ta1/2) …

Two novel low-ε r gallates MGa 2 O 4 (M= Ca, Sr) have been synthesized via a standard
solid-state reaction method. According to the X-ray diffraction results, CaGa 2 O 4 …

Cold sintering is adopted to pre-densify LiF ceramics, where the relative density increases
significantly from 72.1% at 125 MPa to 88.9% at 500 MPa. The following post-annealings at …

In this work, a series of (1-x) MgAl 2 O 4-xMg 2 TiO 4 (expressed as (1-x) MA-xMT)(0.0≤ x≤
0.9) ceramics were successfully prepared via a solid-state reaction, and the effect of Mg 2 …

BaF 2 is a low-firing fluoride with excellent microwave dielectric properties, while the
densification of BaF 2 ceramics is challenging via conventional sintering. In this work, dense …

Glass with high visible-light transparency is widely considered as the most important optical
material, which typically requires a processing temperature higher than 1000° C. Here, we …

SrF 2 is a promising low-ε r fluoride with outstanding microwave dielectric properties, while
densification of SrF 2 ceramics is challenging via traditional thermal sintering (TTS). In this …

K metal batteries are one of the most promising designs for high energy density storage.
However, dendrite growth and volume expansion of K metal anode severely lower their …

A sustainable cold-sintering process was adopted to fabricate composites of (1–x)
SrFe12O19–x Li2MoO4, x= 0.4, 0.5, 0.6, and 0.7 with density up to 91%, and their broad …