Abstract Al–7Si, Al–7Si–4Zn, Al–7Si–4Zn–3Cu alloys were produced by permanent mold
casting method to investigate the effects of copper and zinc additions on the machinability …

In this study, the hypoeutectic Al–7Si based alloy containing Zn and Cu was severely
deformed with multi-directional forging (MDF) process at 200° C. The samples were placed …

Effect of zinc contents on the structural, mechanical and tribological properties of EN AC-48100
(Al-17Si-4Cu-Mg) alloy Page 1 Journal of the Faculty of Engineering and Architecture of Gazi …

To investigate the effect of the arc re-melting on the microstructure, mechanical and
tribological properties of the 390A alloy, its ingot produced by the conventional induction …

In the present study, a prediction model was created to predict the impact of B 4 C content,
milling time and matrix size on the hardness and density of AA2024-B 4 C nanocomposites …

Bu çalışmada ağırlıkça% 5 ile 50 arasında farklı oranlarda çinko içeren on adet ikili
alüminyum-çinko alaşımı kokil kalıba döküm yöntemiyle üretildi. Üretilen alaşımların …

In this study, mechanical and tribological properties of multi-directional hot forged Al-7Si-4Zn-
3Cu alloy at different cycles were investigated. Multi-directional hot forging resulted in both …

This study was initiated to compare the tribological performances of a 5754 quality
aluminum alloy after hard anodic oxidation and microarc oxidation processes. The structural …

Effect of zinc contents on the structural, mechanical and tribological properties of EN AC-48100
(Al-17Si-4Cu-Mg) alloy Page 1 Journal of the Faculty of Engineering and Architecture of Gazi …

In this study, the wear behavior of cold worked (Ballised) CuSn5 bushings was investigated.
Ballising is a kind of cold working process applied to hole surface which impart negative …