Babbitt alloy, a commonly used wear-resistant coating material, has a low hardness. This
causes severe plastic deformation, detachment or heavy wear to easily occur under low …

WC-10Co cemented carbides reinforced with 0, 0.5, 1, and 2 wt% graphene nanoplatelet
(GNP) were fabricated by ball milling and spark plasma sintering (SPS). The microstructure …

This study introduces laser irradiation into the electrodeposition of Cu-Al 2 O 3 composite
coatings. The cavitation bubble generated by laser breakdown in the solution caused strong …

This paper discusses the results of a study to determine the effect of the chemical
composition of two tin-based bearing alloys (B89 and B83) on their tribological properties …

A cross-scale analysis method for predicting the compressive mechanical properties of tin-
based bearing alloy was proposed based on microstructure finite element simulation and …

In the present study, three different methods including ultrasonication (U), low-energy mixing
(LEM), and high-energy ball milling (HEBM) were used to mix Al powders with graphene …

WC-10 wt% Co cemented carbides containing various amounts (0–4 wt%) of SiC
nanoparticles were fabricated by vacuum sintering. The influence of SiC nanoparticles on …

To enhance the high-temperature strength and wear resistance of pure zinc, Zn-matrix
composites containing 5, 10, and 20 vol% Cr particles were fabricated through melt stirring …

摘要在工业领域中, 通过铸造所制备的巴氏合金往往存在缺陷. 为了探究如何减少巴氏合金在
组织和性能上的缺陷, 对比了通过传统浇铸和冷金属过渡焊接(CMT) 两种方法在20 …

Pure Cu and Cu/TiO2 composite powders with 10 and% 20 wt% TiO2 were synthesized via
chemical precipitation method. The initial precipitates were obtained by adding ammonium …