Iron-rich intermetallics in Al-Si alloys pose a major challenge in aluminum recycling. Virgin
Al-Si alloys typically contain a minimal iron concentration which enhances properties like …

The paper concerns modeling the microstructure of a hypereutectic aluminum-silicon alloy
developed by the authors with the purpose of application for automobile cylinder liners …

Alloys of FeNiSiB soft magnetic materials containing variable Fe and Ni contents (wt.%)
have been produced by melt spinning method, a kind of rapid solidification technique. The …

In this work, a novel Al-PO (Al-6Si-2.5 P-Al 2 O 3) master alloy has been developed via the
in-situ salt-melt reaction route. The primary Si refinement and eutectic Si modification have …

Sažetak In this study, an induction air heater prototype that is designed to supply hygienic air
was analysed. The purpose of this paper is to determine the distribution of energy losses …

In this study, Al-17% Si alloys were dual modified by fine-grained structural materials (FSM)
according to structural heredity. Microstructure and thermal analyses were undertaken to …

This study unpicks the influence of the glass tube suction casting (GTSC) with different inner
diameters (8, 10, 12 and 14 mm) on the solidification process of the hypereutectic Al–Si alloy …

Abstract One Al–17Si–4Cu–0.6 Mg–3Zn (B390+ 2 wt% Zn) alloy and five B390+ 2 wt% Zn–
Sr alloys were produced by permanent mold casting method. Microstructural evaluations …

In this work, Al (OH) 3 nanosheets are synthesized in situ on the surface of an Al-20Si alloy
via the water bath method, and Al–20Si@ Al2O3 composites are then obtained after …

In the present study, the effects of Ag and Bi additions (1 wt.%) on the microstructural,
thermal, mechanical and electrical properties of Sn–5Sb solder alloys were investigated by …