Overall cooling performance evaluation for film cooling with different winglet pairs vortex generators

H Deng, J Teng, M Zhu, X Qiang, S Lu… - Applied Thermal …, 2022 - Elsevier
Previous studies have shown that the film cooling effectiveness can be improved by using a
winglet pair vortex generator upstream or downstream of the film hole, but these studies …

Combined-hole film cooling designs based on the construction of antikidney vortex structure: a review

R Zhu, G Zhang, S Li, G Xie - Journal of Heat …, 2021 - asmedigitalcollection.asme.org
Film cooling is one of the most efficient and widely used cooling methods for high-
temperature components. The interaction between the film cooling jet and main flow creates …

Film cooling comparison of shaped holes among the pressure surface, the suction surface and the leading edge of turbine vane

Y Jiang, H Li, R Liu, Z Tao, Z Zhou - Applied Thermal Engineering, 2023 - Elsevier
The present study employed commercial computational fluid dynamics software ANSYS
2019R3 to explore the adiabatic film cooling effectiveness and the net heat flux reduction …

Effects of diameter ratio and inclination angle on flow and heat transfer characteristics of sister holes film cooling

J Zhou, X Wang, J Li, H Lu - … Communications in Heat and Mass Transfer, 2020 - Elsevier
In order to investigate the flow and heat transfer characteristics of sister holes cooling
method, sister holes cooling structures have been applied on a flat plate with four primary to …

Multi-objective optimization of round-to-slot film cooling holes on a flat surface

Y Huang, J Zhang, C Wang - Aerospace Science and Technology, 2020 - Elsevier
This paper describes a multi-objective optimization method for round-to-slot shaped film-
holes (RTSH) using computational fluid dynamic analysis and surrogate model …

Research progress of kidney vortex and its application in film cooling

A Li, G Li, Y Ruan, C Kang, R Wang, X Lu - … Journal of Heat and Fluid Flow, 2025 - Elsevier
Kidney vortex is a typical flow structure formed by the interaction between jet and cross flow.
One case where kidney vortex is frequently observed and studied is film cooling: jet from a …

Improving turbine blade endwall cooling using air/mist mixtures and composite ramp-groove structures

Y Song, S Han, J Xing, R Zhang, N An, T Huo… - Thermal Science and …, 2023 - Elsevier
Serrated grooves enhance the film cooling performance of turbine blades through extended
lateral diffusion when the air is mixed with mist. This work proposes a novel composite …

Effects of side hole position and blowing ratio on sister hole film cooling performance in a flat plate

H Wu, H Cheng, Y Li, C Rong, S Ding - Applied Thermal Engineering, 2016 - Elsevier
Three kinds of sister hole and one single cylindrical hole were experimentally studied in
order to analyze the effects of side hole position and blowing ratio on film cooling …

Numerical simulation of two-phase flow: Air-mist film cooling over a flat plate

A Dwivedi, S Sarkar - International Journal of Thermal Sciences, 2023 - Elsevier
The performance of air-mist film cooling is evaluated for varying mist concentrations (2–7%)
and droplet diameters (5–30 μm) using the Euler-Lagrange approach with the k− ε …

Enhancing thermal field prediction in a jet in cross flow through turbulent heat flux model optimization by using large eddy simulation

K Mazaheri, SAA Mehrjardi - International Journal of Thermal Sciences, 2025 - Elsevier
High fidelity big data obtained from highly accurate large eddy simulation (LES) was utilized
to enhance current models for turbulent heat transfer, boosting the precision of the realizable …