This review highlights the potential of Kelvin probe force microscopy (KPFM) beyond
imaging to simultaneously study structural and electronic properties of functional surfaces …

As a result of the continuous drive to fabricate electronic devices on lightweight, large-area
plastic substrates by low-cost processing techniques, organic electronics is currently running …

The remarkable development of organic thin film transistors (OTFTs) has led to their
emerging use in active matrix flat-panel displays, radio frequency identification cards, and …

Charge migration along DNA molecules has attracted scientific interest for over half a
century. Reports on possible high rates of charge transfer between donor and acceptor …

The phase mode of electrostatic force microscopy (EFM-phase) is a scanning probe
microscopy (SPM) technique used to measure electrostatic force gradient. EFM-phase has a …

Conductive atomic force microscopy (CAFM) is introduced to perform electrical
characterization of organic photovoltaic blends with high spatial resolution. Reference …

Nanoscale surface patterning and polymerization of caffeic acid on 4-aminothiophenol-
functionalized gold surfaces has been demonstrated with dip pen nanolithography (DPN) …

Optoelectronic devices that can remotely sense discomfort or damage inside the human
body are needed to improve the quality of human life. Herein, we report on the effective …

The coupling of all twelve possible conformational modes of DNA duplexes and four pair-
wise correlations among them to positive charge (hole) motion through these biopolymers …

Solvent-induced performance deterioration in corona charged polypropylene electret filter
media was studied. Electret media, exposed to isopropanol (IPA) in the liquid phase …